ported head and new cam?

[Martin Blair]

i am looking for more power but dont want to change pistons or reliablity so i was thinking of getting the head ported and 3 agngle valve job and a new cam, like aH.R.C so its reliable, how much power should i expect?

you should get a lot more flow and a pretty hefty gain up top and mid range but depending on your cam you may lose some low end

WHOA ur like 20 minutes away from me...wanna go riding sometime or somethin? PM me or gimme a aol sn aim sn or msn/hotmail addy

[JD400exrider]

You won't loose much low end with the HRC cam. I am running one and i did not see much low end loss if any. Did see a nice increase on the mid to top end.
I would put a high compression piston in if you are going to do a cam. Running a higher performance cam with the stock compression you will lickley loose low end. Higher compression helps on the low end. It is woth the 125-130.00 for the piston.
you can go with the stock bore rather than having it bored if you want to save a little coin.

Good Luck

where can i order the HRC cam for the least ammount of dough?

[Martin Blair]

sure i will im you man i would get one directly from honda.

aiight send me an im bro my sn is right in my signature