scooter8
06-09-2003, 06:25 PM
I'm getting my motor bored and stroked and I was wondering what bore size would run cooler either ..120 overbore or the 440 kit with the sleeve or should I only bore it .080 over.and what compression ratio would be best 11:1 or 12:1.I'm going to use a ross piston and oversized head studs.The crank is getting a 4.5 mm stoke job with a good ''H"beam rod installed.I already have a pringy oil tank and air scoops and am planning to get a fst auxilary cooler for the head.I just can't decide on the bore size or compression ratio to run.What do you guy's think would be the best combo to put on the stroker.Thanks