bent frame

I have 96' 300ex and when i resently started on a winter rebuild I noticed that the rear of the frame ,above the swing arm, is bent to left side of the bike. I have broke the section where the seat latches onto completly off but don't under stand how the entire frame got tweaked over any suggtions on how too correct needed








96 300ex:.40 overbore, wiesco 11:1 , fourstroke tech cam @rockers, fmf powercore IV exhaust, K@N stage 3 jet kit 140 main
cam2 110 octane , belray oil.

[Scott]

I think I'd check a motorcycle junkyard for another frame. That would probably be the cheapest way to get a straight frame. Once you bend it, even if you straighten it, the metal has streched and is weaker, so it's only a matter of time until it bends again.