quadman21
06-03-2003, 02:53 AM
I just got me engine back from having 2nd and 3rd gears put in. It's a 440 and when I got my head gasket, it was fiber instead of the stainless. I already ran it through one heat cycle (about an hour and half of riding) and I checked and retorqued my head nuts. Only two were below 33 ft-lbs. My question is, should I ride some more this week and do this again Saturday to be on the safe side before I race Sunday or should it be fine now? Just for FYI, I also had TC studs put in while I had it apart.