Fender Bender
05-30-2003, 07:41 AM
I just downloaded a program called Electronic Cosmo's MPEG Suite v1.5. I can't figure out how to use it, so I thought maybe someone could help me. I want to convert AVI files that I record from my Digital Camera into MPEG format so I can send it to freinds over the internet without it taking an hour. Here is what it tells me under the configuration tab: (I'm assuming I have to configure it first)
Theres a column called Encoder with a list of choices
Codec
1. EC98ENC (c) Electronic Cosmo
2. Blade ENC (c) Tord Jansson
3. Plugger + (c) Alberto Demichelis
Mode
1. Stereo
2. Joint Stereo
3. Mono
4. Dual Mono
Bitrate
(counts from 32-320 Kbit/s)
Layer
1. Layer I
2. Layer II
3. Layer III
Priority
1. Time Critical
2. Highest
3. Higher
4. Normal
5. Lower
6. Lowest
7. Idle
Then there is 2 Checkboxes after that:
1. Delete source files after encoding?
2. Always overwright?
And then you choose an "Output Directory" which is c: on default.
I know this is long, but any help will be greatly appreciated. Thanks alot, Fender.
Theres a column called Encoder with a list of choices
Codec
1. EC98ENC (c) Electronic Cosmo
2. Blade ENC (c) Tord Jansson
3. Plugger + (c) Alberto Demichelis
Mode
1. Stereo
2. Joint Stereo
3. Mono
4. Dual Mono
Bitrate
(counts from 32-320 Kbit/s)
Layer
1. Layer I
2. Layer II
3. Layer III
Priority
1. Time Critical
2. Highest
3. Higher
4. Normal
5. Lower
6. Lowest
7. Idle
Then there is 2 Checkboxes after that:
1. Delete source files after encoding?
2. Always overwright?
And then you choose an "Output Directory" which is c: on default.
I know this is long, but any help will be greatly appreciated. Thanks alot, Fender.