Pro Design Case Saver installation

[knighttime]

Have n e of u dudes ever installed one of these. I have the big spacer on top and the little spacer on the bottom screw. It also looks like the stock sprocket cover is no longer used. Is this correct?:confused:

Chit can the stocker one it won't work with the new one,,,and you'll also need to remove the bolt with the black rubber fastner to hold the neutral switch wire..goin down next to the shifter, not actually remove it but relocate it,,it should bolt up pretty flush,,I can't remember if mine came with spacers or not..:confused:

yes you are right, the stock cover has to come out. look at the stock gaurd there should be spacers welded on to it, just use that as a guide. As for the cable guide I just left it on the bolt and it works fine.

[RAPTORAZ]

You can use the stock guard on top of the case saver. All you need is some flat washers( to use as spacers) and some longer bolts. Both will fit easily. However, the stock guard covers up the nice shiny Pro-Design one.:)

[knighttime]

The stock guard isn't goin' back on. It looks to good without it.:D