View Full Version : Pilot Screw turns?
MikeL250X
12-31-2001, 09:00 AM
I am going to install a 42 pilot on my friends 400, we don't have a shop manual, is the pilot 2 1/4 turns out stock? thanks guys
The pilot screw should screw all the way in until its seated snug,,,are you talkin about the air/fuel mixture screw??
MikeL250X
12-31-2001, 02:43 PM
rico, on my 250x in the manual it gives the number of turns out, not sure if the 250x has a a/f screw or not. I didn't get to taking out the carb yet, so I'll double check if the pilot screws in any before I remove it.
the pilot jet screws down snug...
the pilot screw should be ~2 turns out (mine was 1 1/2 from the factory)..
Leo
knighttime
12-31-2001, 09:01 PM
honda gives the 400 to ya very lean
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.