T-9 pro series baja itp rims

[honda 400ex 69]

im going to buy all 4 rims but im not sure what to get. these looked pretty good and will only run me $92 each for the 10x5 fronts and only $87 each for the 9x9 Rears.
if there is a better rim out there for around this price let me know

thanks

[Hoodeye3]

I was in the same situation a few weeks back looking for a good quality , strong & light wheel to race on and after some extensive searching I opted to go with the Bajas all the way around on my 400. The structural quality is very good, the finish quality is not quit as good as Douglas but close (nothing some mothers wont overcome). So far I only have one race on them but all is well and I am happy with my decision!~

[honda 400ex 69]

where did u get them? and were the prices pretty much the same as what i listed

thanks

[remlapr]

I have the rears - I see these as the middle ground between some regular .190 rolled edge and some low end beadlocks. So far I am happy with them and I think they look good - much better than the ones with the welded-in rings. I cleaned mine up with some polish when I got them - what a waste of time, when you ride nasty woods trails there just isn't really a point in trying to make your quad purty.

[JOEX]

They are near the top on my list of things to buy:) Either those or riding gear.

Joe

[cdalejef]

The standard Douglas Ultimate's seem to be a little stronger and about the same price.

[Hoodeye3]

I picked mine up from Rocky mountain here in Utah, the prices you listed at the top are very similar to what I paid + or - 2-3 dollars. good luck!