removing axlenut

[jaywoodsrider]

i need help asap

[jaywoodsrider]

i got the ring removed but the nut does not slide offf of the axle

[Narly R]

well if ya got the ring off that mwans you can turn the nut on it, right? It should just slide off!:huh Try puttin some WD-40 on it and let it set a while then maybe tap it wif a hammer!??

yup u might get more help in the suspension forum lol, does it move at all? cuz on j 37 he had to take a file and file off a lil ridge that developed on the outside of where the ring goes , if its seized worst comes to worse u gotta cut it off the axle and buy the thread part from honda and a aftermarket nut

[jaywoodsrider]

i finally got the thing off after i beat the crap out of it with a hammer. I must of came down wrong on a jump because one of my bearings is totally gone, but i think the other one is still good.

[killed300ex]

i had the same problem i found out what it was though the ring that the little clip was in was bured on the edges and you just had to file it down file down all the little holes before you put it back on
killed

[JOEX]

i finally got the thing off after i beat the crap out of it
That's how I get my nuts off!:eek: :D