400 ex camshaft question

[GB440]

I have just put a WebCam 450/451 in my 400ex. The directions say to leave the 2 setting pins out. ( one goes on each end of the stock cam, probably to keep the cam and bearings from walking around)
Anyway, I was just wondering if I leave then out, what's going to keep the cam and bearings from walkiing around? Is anybody else running one of these cams?

P.S. The WebCam is a little longer than my stock cam, so the pins won't go in anyway.

Thanks for any info!

GB

[Castor-426ex]

there werent pins on the ends of my stock cam or my hotcam

but there are bearings....the pins are in the decompressor....i dont think youll use that on the web

[GB440]

The setting pins I'm referring to, fit into the head, at the ends of the stock camshaft bearings. If you had a stock 400ex, you would of had them too. Thanks

GB

[GB440]

Just wanted to put this back on top.

[Castor-426ex]

the dowels?

unless that cam is just massive i dont know why you would take the dowel pins out:eek: :confused:

[gojk]

I think the pins you are referring to are the oil lines. Don't pull them. The stuff most the cams don't use is the spring and plunger in the head on the intake side right by the cam. Also leave off all of teh decompression stuff off of the new cam. This is how the Hotcam works so I am not sure with the webcam but it should be the same.