PDA

View Full Version : What plug in 250r


R-Crazy
04-12-2003, 07:56 AM
what plug should i use in my 250r w/ the mods in my sig. i heard NGK b8es was good, and i have some at the house, is that the right one. thanx

dave
300exazzkikr
04-12-2003, 08:47 AM
you'll be fine with a br8es
trailburner
04-12-2003, 08:56 AM
Originally posted by 300exazzkikr
you'll be fine with a br8es
I 2nd that, ran them for years never had a prob;)
R-Crazy
04-12-2003, 11:39 AM
no, b8es, no "r". should i get different ones?

dave
300exazzkikr
04-12-2003, 12:19 PM
THe "r" is for a resistor type plug. Basically it's there for if you have lights and stuff. It's basically the same plug but i always get the resistor type.
R-Crazy
04-12-2003, 01:50 PM
ok, i dont have any lights, the only electrical is the basics. Thanx. Its sounds like ill be okay.

dave
stocktires
04-12-2003, 02:41 PM
I run br8es', but I guess I'll switch to b8es', they're prolly a few cents cheaper
OutlawEX
04-12-2003, 06:40 PM
Originally posted by 300exazzkikr
you'll be fine with a br8es
250rmike
04-13-2003, 12:38 PM
my bike began to not run as well when i put my new pipe on even with the jetting changes so i decided to try a few different plugs i beleive it was the br8eg it has a real smll point i beleive it was the iridium plug but it did wonders for the bke in like 10 min it ran perfect and pulled alot harder than before
AndrewRRR
04-13-2003, 03:17 PM
When my R was stock I used the normal BR8ES, but with the big bore stroker I was told to run the BR8EG or BR8EV (or the BR8EVX but they are spendy). It would probably run on ES plugs but I just run EG's and EV's. The EG has a smaller electrode than the ES and the EV's is even smaller than the EG's.
I don't think the EG or EV is irridium or platinum but I believe the EVX is.