Banshee Carb Jetting

[CHAUNCY]

I am currently building a drag shee. I plan on running out of frame drag pipes, a full race port, and 34mm PJ flat slide carbs. What are the recommended jetting sizes for the mains and pilots. Also what is the clip position on the needle. Any help or links to useful info would be greatly appreciated. Also what type of spark plugs would be good to run on this ???

[RAPTORAZ]

www.bluetraxx.com might be a better place to ask these questions.

[CHAUNCY]

Originally posted by RAPTORAZ
www.bluetraxx.com might be a better place to ask these questions.

Yeah, I know, its a yamaha. I tried www.glamisdunes.com and got one helpful person. I am not registered at bluetraxx yet so I might register and try later there:ermm:

[speedy400]

the Best place is bansheehq.com pretty much the same as this place.-darren

[CHAUNCY]

Originally posted by speedy400
the Best place is bansheehq.com pretty much the same as this place.-darren

Alright,
thanks a ton

[out4sand]

You'll want to be running NKG 9ES unless your running alky then I'm not sure. As for the jetting that can all depend on the work that is going to be done. You might zap Dan an email at Patriot Racing; he is super helpful and very knowledgeable on built shee's.

www.patriotracing.net

[OutlawEX]

Originally posted by RAPTORAZ
www.bluetraxx.com might be a better place to ask these questions.

Ya i suggest there alot of yama peeps