PDA

View Full Version : someone please help quick!



300EXrider02
03-28-2003, 08:37 AM
my carb is going down hill...
i fixed the needle and now it doesnt bog down about 3/4 or a little less throttle and on, but the start up to about half boggs out, and almost seem to starve for gas...what should i do??!?! please hel0p quick because i need to get going and ride

is it the main? i am at a 128 now, holes in lid, and a pipe...should i change? fuel, screw?

300EXrider02
03-28-2003, 09:37 AM
god damn guys, 10 views and not one damn person knows anything???

300EXrider02
03-28-2003, 09:55 AM
*sigh* 110 views

if anyone wants me to re-word it i will, or anything, plase help though i treid unscrewing the fuel screw and seeding it again, but no luck

gojk
03-28-2003, 09:55 AM
It sounds like the pilot might be clogged. Did you just have it apart? Try cleaning it.

300EXrider02
03-28-2003, 09:56 AM
ill take a look again, thanks for the input

300EXrider02
03-28-2003, 11:06 AM
well thanks for all the help, i guess i will have to drive 35 good miles to my dealer to have them fix it for me, it bogs out and sounds like almostthe choke is on, it goes great after 1/2 throttle but from teh start to half, it sucks, i jsut took apart the whole carb, nothing looked bad, i am jsut waisting my time and know one will even help, i jsut took the carb off twice, and nothing look wrong, no please help

Dune Surfer
03-28-2003, 11:40 AM
I would help if I knew the answer, I think the same goes for most people viewing your post.:) Jetting problems can be such a pain:grr If you can't get it figured out buy a 400 carb. Good luck

300EXrider02
03-28-2003, 03:03 PM
thanks, anyone else?:huh :(

shamisc
03-28-2003, 08:51 PM
Don't get your panties so twisted! This is a very helpful site, but not everyone knows the answer to your question! Tone it down a little and have some patience grasshopper! Sounds to me like it could be a little too rich in the bottom. What does your plug look like? Some aftermarket pipes don't flow as well as factory and could result in a rich mixture. If you say it runs fine 3/4 - full then I would say go down a couple sizes on your slow jet. A plug reading will tell all. :D :eek2: