Magura Clutch PPL

[Scott400EX]

OK heres whats happenin.
I have eveerything installed and pull the lever and the clutch arm only moves about 4mm instead of 9.5 like its posed to.
What could the problem be?
Does it need Bleeding?
The fluid reservoir is full.
THis all started when i took my side case off to remove the return spring.
If i use the stock cable clutch the arm moves like its supposed to.
Help!!

[Extremeracer167]

yup try bleeding it. But does the clutch engage when u pull in on it? Mine was the same way. I thought there was no way it would work, but after a while, it starts getting a better pull. But try bleeding it, even though it should already be bled

[Extremeracer167]

also, did u adjust the red know on the lever. Try adjusting that, that actually makes a BIG differance

[Scott400EX]

Yeah i have tried adj the red knob all the way both ways and its the same. When it is all the way pulled in the clutch does not disengage totally it will start to slip jsut a little so it doesnt need much more pull to be correct.
Ill get a bleeder kit and see if that works.