Seany_KOTF
04-18-2015, 01:14 PM
Stripped mine down to the frame this winter to clean, paint and lube everything up for this year....When putting my spindles back on I had a hard time getting the lower ball joint on one side to stop spinning while tightening down the nut. I know all the tricks...(use a pry bar, place a jack under it...etc.) but it still was putting up a fight. So i took the spindle off, cleaned up all the excess grease that splooged out onto the stud and inside the spindle bore then i took the nut and ran it up and down the threads a few times to clean em out. Tried once more to install the spindle and noticed that the reason its spinning is that the nut it reaching the bottom of the threads!!! I guess at some point they had gotten a little loose and the constant rocking back and forth wore out the spindle bore so i no longer provides enough friction to hold the stud in place. I guess im posting this now because ive thought about perhaps placing a washer or two between the nut and the spindle to see if i can get enough torque onto the nut to hold it in place. I am in no financial condition to purchase new spindles or a arms right now so i have to come up with something...
what do ya'll think, will it hold?
what do ya'll think, will it hold?