spencer450r
01-19-2015, 08:41 PM
Up for sale is a 2009 can-am ds 450 race ready. I am the original owner. 100% turn key ready for the 2015 season. The motor was gone through by Rossier engineering. New crank, crank bearings, new piston. Motor wasn't blown up crank bearings were starting to go so replaced everything with new parts receipts and paperwork to prove the work was done. 2.2 hours on the motor. 13.8 hours on all aftermarket parts.
Parts list.
Suspension-Chassis-controls
Motowoz long travel shocks front and rear set up for 180lbs rider
Walsh long travel a-arms. New heim joints and new ball joints
Can am xmx steering stem with xmx bars and pro taper bar pad
Walsh HD tie rods with new tie rod ends.
Walsh pull rod
Rath bumper
Rath nerfs
Odi grips
DWT champion in box rims. With gold speed tires
XMX rear axle with new carrier bearings
Precision steering damper with lower mount
Engine
Brand new crank with bearings
New 14:1 JE piston
Dual exhaust cams
Oil squirter mod
Hinson clutch basket with new fibers and steels
Race ECM
Epoxied head
Brown injector (quad runs on e-85) easy to switch to 110
Power commander V with custom tune from Rossier Engineering
Full Rossier exhaust
Rossier free air kit
All case updates have been made
Can Am race department wire harness
Dynoed at 54HP
BCS sprocket retainer
BCS shark fin
BCS case saver
BCS inline cooler
BCS battery box
BCS chain guide
New sprockets and chain
6800 obo have almost every receipt and receipts for the motor work. Call/text 320-980-8260 or email spencer450r@yahoo.com Located in Saint Stephen MN
Parts list.
Suspension-Chassis-controls
Motowoz long travel shocks front and rear set up for 180lbs rider
Walsh long travel a-arms. New heim joints and new ball joints
Can am xmx steering stem with xmx bars and pro taper bar pad
Walsh HD tie rods with new tie rod ends.
Walsh pull rod
Rath bumper
Rath nerfs
Odi grips
DWT champion in box rims. With gold speed tires
XMX rear axle with new carrier bearings
Precision steering damper with lower mount
Engine
Brand new crank with bearings
New 14:1 JE piston
Dual exhaust cams
Oil squirter mod
Hinson clutch basket with new fibers and steels
Race ECM
Epoxied head
Brown injector (quad runs on e-85) easy to switch to 110
Power commander V with custom tune from Rossier Engineering
Full Rossier exhaust
Rossier free air kit
All case updates have been made
Can Am race department wire harness
Dynoed at 54HP
BCS sprocket retainer
BCS shark fin
BCS case saver
BCS inline cooler
BCS battery box
BCS chain guide
New sprockets and chain
6800 obo have almost every receipt and receipts for the motor work. Call/text 320-980-8260 or email spencer450r@yahoo.com Located in Saint Stephen MN