PDA

View Full Version : Raptor 660 parts



f4istunna
05-12-2014, 06:56 AM
01-05 yamaha 660 raptor parts.

frame/title SOLD
Dg nerf bars with heelguards SOLD
rear wheels/razrs SOLD
Front bumper SOLD
6 pack rack SOLD
Plastics SOLD
Swingarm/axle SOLD
Clutch SOLD
Starter motor SOLD


Motor ran good
Cylinder head complete with valves good journals, comes with rocker cover/rockers but the rocker box has a small chip around one of outer bolts from someone overtightening a bolt didnt notice any leaks from it. 250 for all of it
Stock cam with gear/decompression 70
Cylinder/piston 80 100mm stock bore
01 bottom end SHIFTED FINE through all gears 250
starter clutch and flywheel with gears 125
stator and cover 25
clutch cover and waterpump 20
Carbs 100
Airbox with Pro Flow Billet adapter and foam filter, lid and intake tubes (lid has small vent hole) 40
Full set stock a arms good balljoints 75
radiator with fan 25


front tires pretty worn wheels good 30
01 rear shock remote resi 50
left and right spindles 20

2002


rear wheel hubs 20

stock stem with pitman arm 20
ignition switch and key 20
headlight run switch with choke lever 30
subframe blue good threads 20
front brake calipers/lines 30
front master cylinder / lever 25
L & R spindles 20
L & R front wheel hubs/rotors 20
rear 02 shock 20
aftermarket Clutch lever/cable 15
thumb throttle and cable 20
headlights r has damaged trim ring, one of tabs is cracked but rest intact 50 for pair
gas tank with cap/petcock 15

01 bottom end good cases and crank, bad 2nd gear 80
gas tank with cap 5
stock front shocks 10
left and right spindles 20
stock bumper dented at bottom 5
rear wheel hubs 20
stock clutch lever/perch with cable lever is bent has parking brake peice 5
swingarm pivot bolt and nut 5
front wheel hubs with rotors, need bearings replaced 20 pair
clutch cover (right engine cover)10
blue subframe straight grab bar threads out and uses nuts/bolts 10
stock clutch lever/perch with parking brake and cable good 10
52 tooth gear off 01 that goes behnd starter clutch good. 15
seat that needs recovered, good pan/foam 10
white gas tank plastic/cover 5


have hardware like engine mounts, swingarm bolt etc ill throw in if buy something else or sell for few bucks.