thechamp27
04-29-2014, 08:19 PM
2003 from what I can tell from the ser number on the case. Fully built Baldwin CRF450 engine removed from a Walsh Racecraft chassis. I purchased the bike this past winter to do a 250f conversion. I know the guys I bought this bike from very well, so I know the history of the motor. I can tell you that it has a full race season on it since the last time it was freshened up, so it may be getting close to time to go through it again. Cylinder is 2 years old, original was found to be out of round and was replaced with a new OEM cylinder at that time. I started the engine up in my shop before removing it and it started and ran fine, had a very light amount of smoke coming from the exhaust, most likely from valve seals leaking a bit over winter. Sells complete as pictured, with the stator, flywheel, clutches etc. Looking to get 1250 shipped to the lower 48.