How to install Kill switch?

[ill_lil_romey]

I just got my new pro design kill switch for my 400ex, can somebody please give me step by step installation process? Thanks
- ROME

[RiPPiNiTuP7]

Here ya go:

http://www.off-road.com/atv/reviews/products/ProDesign/

[ill_lil_romey]

Thanks rippin, that really was a huge help!

[Doibugu2]

ill,

I don't like those directions because you have to cut the wire.

If take off your side panel on the clutch side of the bike, there is your coil. If unbolt the coil from the frame, the wire that you need to splice into is right there and mine actually had a waterproof connector that I could just take apart and plug my kill switch into. And since the your right next to the frame when you bolt the coil back up you can use one of the bolts as your ground. Just make sure you put the ground so its touching the frame.

You may not understand what I'm talking about, but if you take off the side panel and the coil, I bet you'll figure out what I'm talking about.

[QuadTrix6]

i had the same problem go here

http://www.exriders.com/vbb/showthread.php?s=&threadid=32546