help with piston rings?

[stateboy]

I bought a 51mm wiseco piston a guy was unable to use due to a botched bore and was about to install but can not see a "T" on the rings. on the right side of the gap I can faintly see some letters but not well enough to read ( luck it would say DOWN rather than up). There also isn't a thinner corrugated ring beneath the bottom ring like the previous piston. Is this one missing it or does it not require it being a different brand?

[LT80]

If you can see anything on a ring end, that side is up.
No, you don't need that squiggley thing on that wiseco piston.
Make sure the bore guy gives the piston at least .0035 clearance.

[stateboy]

In case you don't hear it enough... your wisdom is greatly appreciated! I am drilling the clutches right now and it seems that scale is lying to me. They started at 214g and I am now looking for a pic of a finished one at 180g to see if I need to cut off more or keep drilling. I am afraid to take off too much near the piece that the little rubber grommet sets in, in case it gets hung up or something.

[LT80]

Thank you. :)
I cut them off about1/2" from the pad.
Where the rubber thing goes gets cut off.