f4istunna
08-17-2013, 07:46 AM
parting good running 03 660. everything is good on quad except starter clutch, and cpl tierod ends. Located near youngstown ohio for pickup, or will ship anything except the plastics and frame. have paypal.
Complete engine 700 (runs strong, bad starter clutch) will split up if enough interest.
Durablue eliminator +4 axle with billet wheel hubs 200 (they are 700 new)
Black Maier fenders (front, rear, tank cover and top peice for hood) very small crack in front hard to notice, bottoms of rears trimmed off. 120 with matching seat
Stock blue full fenders front and rear no cracks but have some stress marks 60 for set
aftermarket header with muffler, loud (not sure brand) looks like the header thats on ebay for 189 shipped. 80 for both
Black rear rims with good stock tires great shape like new tread 100
black front wheels with stock tires about half tread maybe little less 60
Trailtech fatbars with the billet clamp that holds dummy lights and key switch 60
ignition switch with key 25
full set stock a arms with tierods (cpl tierod ends worn) balljoints on arms are good) 60 for all
spindles left and right 25
front wheel hubs with rotors left and right 20
stock steering stem straight 25
headlight run switch / kill switch 30
thumb throttle 20
front brake master cylinder with lever 25
front calipers and lines 25
rear brake caliper 40
rear master cylinder line, lever and resi 20
grab bar stock 20
headlights right side has a damaged tab 60
tail light, lens has crack works 10
swingarm with good axle carrier, good pivot bearings 80
main frame and subframe 70 bos, # ran clean through sherff
rear shock with linkage 40
front shocks 30
airbox with lid and kn filter 30
carbs 70
Wiring harness with cdi, voltage regulator, relay etc 75
radiator with fan 30
im sure i forgot a few things and the smaller stuff like motor mounts, footpegs, etc if not on the list feel free to ask. Tried to post pics but couldnt upload. send email address if want to see pics. ill try and upload again later
Complete engine 700 (runs strong, bad starter clutch) will split up if enough interest.
Durablue eliminator +4 axle with billet wheel hubs 200 (they are 700 new)
Black Maier fenders (front, rear, tank cover and top peice for hood) very small crack in front hard to notice, bottoms of rears trimmed off. 120 with matching seat
Stock blue full fenders front and rear no cracks but have some stress marks 60 for set
aftermarket header with muffler, loud (not sure brand) looks like the header thats on ebay for 189 shipped. 80 for both
Black rear rims with good stock tires great shape like new tread 100
black front wheels with stock tires about half tread maybe little less 60
Trailtech fatbars with the billet clamp that holds dummy lights and key switch 60
ignition switch with key 25
full set stock a arms with tierods (cpl tierod ends worn) balljoints on arms are good) 60 for all
spindles left and right 25
front wheel hubs with rotors left and right 20
stock steering stem straight 25
headlight run switch / kill switch 30
thumb throttle 20
front brake master cylinder with lever 25
front calipers and lines 25
rear brake caliper 40
rear master cylinder line, lever and resi 20
grab bar stock 20
headlights right side has a damaged tab 60
tail light, lens has crack works 10
swingarm with good axle carrier, good pivot bearings 80
main frame and subframe 70 bos, # ran clean through sherff
rear shock with linkage 40
front shocks 30
airbox with lid and kn filter 30
carbs 70
Wiring harness with cdi, voltage regulator, relay etc 75
radiator with fan 30
im sure i forgot a few things and the smaller stuff like motor mounts, footpegs, etc if not on the list feel free to ask. Tried to post pics but couldnt upload. send email address if want to see pics. ill try and upload again later