Roll design swingarm and a-arms, help?

[browndog99]

1718104029171810403017181040311718104032


any help with info on this swingarm and a-arms would be appreciated, i know the swinger is not a no-link, but some of the pics from duncan international website shows a different swinger, look where my dogbone meets the swinger i have two rails instead of just a mount, also the a-arms, any measurements would be great, i think they are +2, but not 100%, and they did make two sets, one for the 86-87, and 88-89, the 86-87 were +2+1. And the 88-89 were
+2+0, any help would be great thx, and any idea what they may be worth?, i have replaced all the balljoints and bushings, direct from page at roll design, expensive! Lol

[browndog99]

1718104033171810403417181040351718104036

[mx91a]

That looks like it might be an early model swingarm. I have the one like on Duncan's web site and it uses a CR250 chain guide it looks like yours uses a banshee style. No big deal it's a great swingarm and will work fine.

[deathman53]

the a-arms are older too. In ~00, they were changed and required the use of 400ex spindles. I have +3 arms that are from 01 or 02 and they use 400ex spindles.

[browndog99]

the a-arms are older too. In ~00, they were changed and required the use of 400ex spindles. I have +3 arms that are from 01 or 02 and they use 400ex spindles.

thx for the input guys, does anyone have some measurements for stock arms, im curious if these are +2 or just standard width