want to buy- a set of junk cases.

[TRUTH]

Hey all,
I have a Laeger rx chassis that I'd like to get modified to house a 250 motor. If anyone has junk cases they no longer need, I could use them to design the needed mounts. I'm in central wi. Thanks! Frank.

[atv fan 28]

How much are you looking to spend. I have a set thats usable, but the left case has been welded on quiet a bit.

[TRUTH]

The only purpose they will serve is to take measurements for fabbing mounts, so not much.

[atv fan 28]

I understand. I would let these go for $100 shipped. But for what you are doing that might be a little too much.

[TRUTH]

WAY more than I am looking to spend for a mock up. Thanks.

[atv fan 28]

no problem.

[C-LEIGH RACING]

I'll check, probably got both, but you'll need to pay shipping.

Neil

[TRUTH]

Absolutely!! Thanks!!!!!

[250Renvy]

Post me a picture - a good one. You may not need the cases.

I have a Laeger RX chassis I converted back to a 250R - get some pictures so I can see what it is and I'll tell you how to do it.

[TRUTH]

250renvy, what would you like to see pics of? It's a 99 rx chassis that was modified to house a 450r motor. I plan to have a local fab shop mod the frame to install a 250 motor. Any help would be appreciated!

[250Renvy]

Just the bare frame where the motor would sit as well as the footpeg area where the frame joins the lower rail.
Did yours come with or have radiator mounts in it already?

Is it stock linkage?

I bought footpeg mounts, radiator mounts and headstay mounts from Laeger for mine.

[TRUTH]

Hey, it's a narrow cr500 link, the 450 motor and rad were installed before I bought it. I can snap some pics for you, the quad is currently together. Thanks! Frank.

[trx250racer]

If Niel doesnt have them... I have a good used right side case for $50 shipped and I can give you a junk left side case for free.