Finally an aftermarket frame.

[Velvet-Casket]

I got an Attitude and 88-89 pro-link. Im not sure if I should use it for my trx, or for a later project. I like my trx pretty much all black, but it still might look nice with an aluminum chassis.
http://i45.tinypic.com/34o313o.jpg

[k7mm]

Wow,that is a serious upgrade!Very nice!!!
Are you the one that won the auction on eBay. I didn't bid,just watched to see what it would go for.
Also,that is one serious shipping box!
P.S. You could always paint it with automotive black paint. And then if you ever wanted it raw again,or had to fix cracks,(hopefully not),you wouldn't have to deal with powdercoat.They have one step automotive enamel that you can add a hardener to,that works really good.

[Velvet-Casket]

No I bought it from a guy off this site.i paid alot less than the one that was on eBay.

[k7mm]

Originally posted by Velvet-Casket
No I bought it from a guy off this site.i paid alot less than the one that was on eBay. Ok,I see. Yeah,almost 2 grand for that one on eBay.

[Velvet-Casket]

Frame came in. I was wondering about what to do on the chain slider, the oem frames have a mount on bottom frame underneath the engine sprocket, the attitude doesn't have a mount, and you can see it rubbed in the past.
http://i45.tinypic.com/zxqqz6.jpg
http://i46.tinypic.com/xr5mq.jpg

[87TRX310R]

I would say get a long zip tie and put it through the oem hole and make another on the otherside of the chain slide so when you tighten the zippy tie it will be like a clamp on the underside of the frame:D

[sand_blaster]

You are so lucky I want a LRD frame so bad.

[beobe99]

Awesome Frame!!

As for the lower chain slide I would get the small OEM slide that goes there and self tap it to the frame.. Drill a small pilot hole first and make sure positioning is correct before drilling!!.