JD400exrider
03-14-2003, 05:51 PM
I am looking to send my head in for a port and polish with a re grind on the valves. Has anyone used xr's only. They seem to have been around for a long time and have been reallly helpful on the phone. They really no the honda engines. I also was looking at Pro Fab atv. Just they are quite a ways away. I am in CA.
Also I have ordered a HRC xr400 cam. Is anyone running this cam? After talking to a couple shops they seem to have good things to say about it. (Just a little pricey $275.00) Comes from honda as a hop up cam for the xr 400. I bought it because a couple places told me it was comparable to the stage 2 cam or better and is a drop in cam. Probably the main reason was it was a Honda made part and i feel the quality is there. Any help would be great. I am using it in a 416 with a Ross 10.8-1, New cam chain, port / polish and new vale job. Anything else for insurance?
Also I have ordered a HRC xr400 cam. Is anyone running this cam? After talking to a couple shops they seem to have good things to say about it. (Just a little pricey $275.00) Comes from honda as a hop up cam for the xr 400. I bought it because a couple places told me it was comparable to the stage 2 cam or better and is a drop in cam. Probably the main reason was it was a Honda made part and i feel the quality is there. Any help would be great. I am using it in a 416 with a Ross 10.8-1, New cam chain, port / polish and new vale job. Anything else for insurance?