yfz calipers

[bullett]

For the people who have the yfz caliper swap on the ex, did you use any washers or anything to bump the caliper out at all? I installed my calipers and outside pad is rubbing the rotor. I bought these used and the pads are about through 50% of their life so i doubt its the pads themselves. Any ideas?

[atvrider13]

I didnt have any problems. I bolted them right onto my 400ex spindles.

[odog]

Originally posted by atvrider13
I didnt have any problems. I bolted them right onto my 400ex spindles. for the front and the rear

[bullett]

Only the fronts will work. If I put new pads in the caliper my brakes will be locked up. I'm stumped

[hondaREX]

I believe i had the same question when i installed mine. They had used pads and were already rubbing. Not too much drag so i just went with it. Not sure how new pads are going to work but ill find out someday and post back in the future.....distant future.

[atvrider13]

My pads are used so yeah i dont know with new pads ? And yup fronts only fit