400ex strokers

[odog]

havent been here in a while just checking to see if they're any more 460ex's around to see how there performing and what other mods are done to them thanks.

[atvrider13]

Id like to know too. Mine is a 440 and most of my mods are the same as yours odog.

[odog]

i just added an over sized aluminum oil tank with holes for cooling in it also.

[Wheelie]

The stock head studs on my 440 stroker finally let go after 6 years. A head gasket went last summer, then again shortly thereafter at Winchestor bay in September.

Going to replace the piston when I removed the cylinder to have HD studs installed. Haven't decided which route I'm going to go yet. Either keep it 440cc's and go with a 87mm 12:1 piston (actually will 12.5:1 w/stroker), or go up to a 88mm piston and have a 13.5:1 450ex. Leaning toward 12.5:1 440.

[DragonGunner]

If I did a stroker it would be with powroll....can run any piston and not a special stoker type.....6 yrs is pretty impressive if you didn't already have HD studs....that would be a must for me.

[JOHNDOE83]

wow odog, it has been a long time since you've been around here. :eek2:

[odog]

yea its been a while johndoe whats new with you.I have a few friends that just got bikes and one that went from an 400 to a 660 so im just ready to ride with them i should be out the shop in about a month still recoverying from christmas.