Kill switch mount with bar pad

[AtvKid4Eva]

Hey guys I want to mount my kill switch to my anti vibe clamp, but still keep my pro taper bar pad. Is it possible? Any pics?

[Stickman400]

Utility knife and some creativity? I just cut up my bar pad on the 400 after I installed a billet protector for my Vapor computer that stuck off the front of the bar clamp. I just held the pad up to it and pictured what I would need to remove and then chopped off the least that I could without cutting off too much and then tried fitting it, trimmed alittle more and it fit perfect. The cover holds it nice and tight and it looks factory from the top when your sitting on the quad and from the back. I can snap a pic if you want. Those bar pads aren't much so just try and figure out where to chop the hole in the center where the kill switch will be and go to work. Just take your time and don't take off too much.

[panici33]

I was wanting to do this to mine too and would like to see a pic Stickman. The pic below is of my LTR; I fabbed a mount out of sheet metal and placed it under my clamps. I was thinking about doing the same thing to the Honda but I don't think I will have enough clearance with the mount and gas tank.

[Stickman400]

Alright here's some pics. I didn't take the bar pad off to show you what I chopped off but I think you can get an idea of what I did. I basically just cut a U shape out of the front of the foam and did the same to the cover but left a small piece right in the center with the velcro still attached. I just covered the front of it in electrical tape to make it look alittle better and cover it up. You can see from the first pic that it looks factory from the seat and back of the quad.

http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/20130101_171127.jpg
http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/20130101_171139.jpg
http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/20130101_171238.jpg
http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/20130101_171248.jpg
http://i683.photobucket.com/albums/vv192/Stickman400/Quad%20Pics/20130101_171148.jpg