jrns281
11-07-2012, 07:38 PM
Hi Guys,
OK I just finished a bottom end replacing the crank, bearings, oil seals. Once I installed the starter and clutch mechanisms and use an impact to tighten the variator nut, the whole system get locked up meaning I cannot turn it by hand. Once I untighten the nut, everything is back to free and normal movement, where I can fire up the bike with the electric start. When installing the variator I did make sure the Belt was not pinching when I tightened the nut. I am showing the step-by-step installation to make it clear if I am missing something or just a noob.
OK I just finished a bottom end replacing the crank, bearings, oil seals. Once I installed the starter and clutch mechanisms and use an impact to tighten the variator nut, the whole system get locked up meaning I cannot turn it by hand. Once I untighten the nut, everything is back to free and normal movement, where I can fire up the bike with the electric start. When installing the variator I did make sure the Belt was not pinching when I tightened the nut. I am showing the step-by-step installation to make it clear if I am missing something or just a noob.