apex 90 help..please

[pitdawg]

so we have an Apex 90 2010, very very low hours, started it the other day after its been sitting for a month, rode around the block just fine. Went out to the track and could not get it started no matter what!!!! So far ive replaced the spark plug, pulled apart and cleaned the carb but still nothing! I have a feeling I have no spark, how can I test the coil, cdi or stator????
any help or advice is much appreciated!!! Im starting to really hate this quad!!!!

[strick9racing]

well pull the plug out and kick it over to make sure you have spark or not. if not clean up the pick up on the outside of the flywheel, ive heard of those getting dirty and causing no spark. my apex just had a stator go out but luckily i had a scrambler 50 that uses all the same ignition parts to swap parts around.

Test for Spark... First remove plug and put it on the frame and see if it sparks while turning it over. If not remove plug and boot and then put plug wire to the frame and see if it sparks.. If not then it's either the coil, cdi or stator. It can also be bad wires or a ground. I have all parts you need to just replace all and call it good. New stator, coil and cdi for $125 Shipped. I can also send you some more info on testing things, but it's some times a pain and just better to replace all and ride hard... Let me know thanks hope it helps..

[pitdawg]

i checked plug to frame... no spark, tried 3 plugs!!! borrowed a buddies coil off of his girls drr and still no spark... are ya saying try just the wire from the coil to the frame? btw.. that would be awesome and i will most likely bu that stuff from ya asap! paypal?

Pm sent... Email me back for more info and deals...

Email recived!!

Pictures and in-fo sent.. Let me know thanks-:blah:

[mmsoup]

Make sure the plug boot is making contact

[kfx450]

Also if it has sat for a month check the kill switch

[rd2005]

Mine did the same thing and a wire was not making a good connection, then it fired right up hope this helps.

[dewutfan]

check the compression if its under 125 psi you need rings been there done that and mine dine the same thing fired it up ran great went to restart it nothing checked the compression and that was it ..