PDA

View Full Version : Cr 85



leager-n-ky
10-09-2012, 06:04 PM
I just put a Hinson clutch basket in our cr 85, was installing the motor back into the Cobra frame and happened to move the shifter, and NOTHING, it doesnt seem to be changing the gears, i rotated the sprocket as far as it would go both ways ?????

Any thoughts here ???????

leager-n-ky
10-10-2012, 06:36 PM
the motor kicks over fine, and you can turn the axle with the chain hooked up, and the motor turns, just no action when moving the shifter ???????????????


ANYONE ????????

chunky0071
10-11-2012, 10:13 AM
Assuming it shifted before you put in the clutch basket I would check your stack height on your clutch plates and fibers.

Logan #34's Dad
10-11-2012, 08:44 PM
How's the clutch pull feel? Is it possible the tophat piece that pushes out that is connected to the lever on the cover fell out during install?
Maybe check the otherside where the shift shaft goes on the other side of the engine and make sure the gears are all attached...

leager-n-ky
10-13-2012, 04:58 PM
got it, the gear shift spindle, and the shaft that goes to the shift forks were not aligned... Ole blind man mistake.... Thanks