PDA

View Full Version : oil pump block off plate


my05z400
10-03-2012, 01:10 PM
anyone know where I can get the oil pump block off plate for LT 80?
footy
10-30-2012, 01:09 PM
try CT racing or JL atv
my05z400
10-31-2012, 08:37 AM
you would think CT racing would have them after during a rebuild in Dirt Wheels. I finally made one myself out of Stainless.
LT80
11-01-2012, 03:26 PM
I could have sold 1000.
I think they are a waste of time and $ seeins it just bling.
tjsreptiles
12-02-2012, 07:15 AM
i got mine from jl i pulled the pump out also
250rPRIDE
04-13-2013, 03:32 PM
Make one!!!!
I have made 3 over the years for people and I am far from a machinist.

Find a piece of 3/16" aluminium from anything and take your factory gasket and trace it. First drill the 2 holes since you have more material to work with for drilling. Then Cut it as close as possible to your line with a hacksaw (I had access to a bandsaw) and then clean it up on the grinder. After that I laid a piece of sand paper on a flat surface and decked it flat. Re-install the gasket and your block of plate with the 2 factory allen screws, and bam your done... takes about 10-15 minutes. I polished 2 of them like chrome just to add a little bling..