atvdude
09-03-2012, 03:38 PM
if i could just get some suggestions on where to start with jetting on my fresh rebuilds = 3 machines. dont want them to lean to start.
1st i have a 440ex with stock carb k&n filter with outer wear lid off and stock header(for now) and an aftermarket 2 piece dg pipe, also has stage 2 magnum cam in it.
2nd machine will be my boys. having cylinder bored to 87mm (11:1)so its now going to be a 416ex with half lid (whole in) and uni foam filter,stock header and a WB E-series slip on, stock cam.
3rd machine will have just .20 over bore (namura piston) kN filte, half lid (whole cut in) stock header with WB E-series slip on.
so could i get suggestions on main jets/ pilot jet/ needle clip for starting out. and ille plug chopped if needed.
also any suggestions on if it would be a good idea to run my WB cdi on the 440ex?? came with one of my 400s when i bought it.
well any help will be appreciated.
ps can u buy stock jet kits? instead of going to shop and buying individually??
thanks guys in advance
1st i have a 440ex with stock carb k&n filter with outer wear lid off and stock header(for now) and an aftermarket 2 piece dg pipe, also has stage 2 magnum cam in it.
2nd machine will be my boys. having cylinder bored to 87mm (11:1)so its now going to be a 416ex with half lid (whole in) and uni foam filter,stock header and a WB E-series slip on, stock cam.
3rd machine will have just .20 over bore (namura piston) kN filte, half lid (whole cut in) stock header with WB E-series slip on.
so could i get suggestions on main jets/ pilot jet/ needle clip for starting out. and ille plug chopped if needed.
also any suggestions on if it would be a good idea to run my WB cdi on the 440ex?? came with one of my 400s when i bought it.
well any help will be appreciated.
ps can u buy stock jet kits? instead of going to shop and buying individually??
thanks guys in advance