trx250racer
08-05-2012, 01:01 AM
got this esr pro-x cylinder that is a 370 4mil on its last bore. 80mm so it is a 380 now.
i was going to build a nice dune motor out of this and have it nikasil plated, but plans have changed.
it is very nice and clean and i was told it has about 2 hours on this bore. does need a new pin and circlips, they were not included when i bought it.
$450 shipped
http://i1085.photobucket.com/albums/j438/TRX250RACER/parts028.jpg
http://i1085.photobucket.com/albums/j438/TRX250RACER/parts029.jpg
http://i1085.photobucket.com/albums/j438/TRX250RACER/parts030.jpg
i was going to build a nice dune motor out of this and have it nikasil plated, but plans have changed.
it is very nice and clean and i was told it has about 2 hours on this bore. does need a new pin and circlips, they were not included when i bought it.
$450 shipped
http://i1085.photobucket.com/albums/j438/TRX250RACER/parts028.jpg
http://i1085.photobucket.com/albums/j438/TRX250RACER/parts029.jpg
http://i1085.photobucket.com/albums/j438/TRX250RACER/parts030.jpg