Starter clutch

[dxcody]

Whats the trick to getting these darn things out!

:cuss:

[Pipeless416]

what exactly are you getting stuck on? mine was very easy to change. if i remember correctly, there is some loctite on the bolts going into the flywheel. try putting the entire assembly in a vice with some towels so it doesn't get gouged, then while you're turning the allen wrench(i think that's what is used..? been a while) try tapping it with a brass hammer. this kind of acts like an impact. the slight blows combined with the twisting motion can help break the loctite free. this is all assuming this is your problem..:p

[dxcody]

yea thats what i was having trouble with... My allen wrenches are too short.

The shorter part of the allen wrench, when i put it in those allen bolts, it sets the wrench cock-eyed and wont break those stupid things loose.

Of course i dont have the socket-allen so i could use a rachet.

Guess ill just go buy one tomorrow.

I have takin ones out before, but these are just being a complete whore!