OTMTRX
07-20-2012, 03:28 PM
Pulled this off to go bigger. Stock cylinder bored to 98mm, bored and re-nikasil'd by PowersealUSA. Venom 98mm pump gas piston (12.25:1). Cylinder in great condition, cross hatch still really good, piston has some wear on skirts as expected. Roughly 40-50 hours on both. Will include full gasket kit, only need new rings (CP # CPN2-3858) to bolt on and go. This set-up made just shy of 58hp on my bike. Asking $200 shipped as a gift or cover PP fee's please.
Measurements:
Jug taper 0.1 Thou"
Jug Out of round:- Top 0.4 thou, Mid 0.4 thou, Bottom 0.3 thou
http://i727.photobucket.com/albums/ww274/stewart6111/5c3e9399.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/076dbdc0.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/e5e81265.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/363ca441.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/32ea4ead.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/ae69f470.jpg
Let me know if your interested.
Thanks
Measurements:
Jug taper 0.1 Thou"
Jug Out of round:- Top 0.4 thou, Mid 0.4 thou, Bottom 0.3 thou
http://i727.photobucket.com/albums/ww274/stewart6111/5c3e9399.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/076dbdc0.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/e5e81265.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/363ca441.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/32ea4ead.jpg
http://i727.photobucket.com/albums/ww274/stewart6111/ae69f470.jpg
Let me know if your interested.
Thanks