bogs in air

[y-man]

Alright guys I kinda got a bogging problem. Sometimes when I jump and hit the gas right before I land it bogs out. I heard something about the tip over sensor could be out of whack. Do you guys know what it could be. Thanks for the help

[atvfrk10]

that, or you might need to replace your fuel filter

[y-man]

I checked the fuel filter and it was clean

[gimp419]

If you're fuel filter is clean you need to check to make sure you don't have any water in your fuel. Doesn't take much in the swirl tank (where the fuel filter is) to make it bog on landing. I've had it happen to me many times.

[y-man]

Alright thanks ill check that out. And I just changed the TOS sensor with one from another ltr and it still bogs.

[y-man]

It runs good on the ground but as soon as my back tires leave the ground it bogs out if im on the gas.

[Baracudaaa]

Check all your wires. The key switch wires, if they are even a tad loose will cause that to happen when jumping or in the whoops. Back in 06, and 07 when they came out, a lot of us were hard wiring and soldering the wires directly to the back of the key switch unit.

[culichi]

Ive had the same problem with mine and I havent found out a solution

[y-man]

Alright cool ill check the key switch out thanks. Ya its starting to piss me off. I wanna ride tracks but I don't wanna hit jumps if its gonna bog on me

[BigKidd]

Originally posted by y-man
Alright thanks ill check that out. And I just changed the TOS sensor with one from another ltr and it still bogs.

I had the same problem, CHANGE your fuel filter ! Thats all it was for me. Fuel flow seemed fine, fuel pressure was good. Tried everything, key switch, key switch wires, roll over sensor and whole bunch of other stuff. Finally changed the filter and the bog is GONE !

[madskrillz2]

Like everyone else said, most likely your filter. I tried everything on mine too before I checked the filter.

[BigKidd]

Originally posted by madskrillz2
Like everyone else said, most likely your filter. I tried everything on mine too before I checked the filter.

Problem is you can't tell if their bad by looking at them.

[y-man]

Thanks for the help guys I appreciate it. Im gonna order a new filter tomorrow and give that a try.

[user101]

Have any of you guys bypassed the swirl filter set-up and changed it to an in-line filter?

[BigKidd]

A number of others have done just that and according to them with no problems for several years.

I myself am skeptical, this is fuel injection, not carbureted. Swirl filters are outrageously pricey so I understand the motivation for an in-line.

Give it a shot, who knows...

Y-man let me know how you fare, thanks.

[madskrillz2]

Originally posted by BigKidd
Problem is you can't tell if their bad by looking at them.

You're right. Most of the time you can't. That's what I was saying is go ahead and replace it to make sure. Mine on the other hand was so corroded that it was obvious that was the problem.

[y-man]

sounds good bigkidd. Ill let you know when I get it put in and how it works

[BigKidd]

Originally posted by y-man
sounds good bigkidd. Ill let you know when I get it put in and how it works

All I want to hear is how good it runs when you change it :D

[y-man]

Haha hopefully I get to tell you that

[y-man]

Hey bigkidd its all fixed jumps like a champ now :D

[BigKidd]

Good Job Y-man, glad to hear and thanks for posting, BRAAAAAAAAP !

[y-man]

Thanks I am to and no problem just took little longer to post then I wanted to