Nathan91
06-02-2012, 03:47 PM
I put new brake pads on last weekend and then attempted to bleed the brakes. The reservoir went down about halfway and stopped. And from them on it just stays full no matter how much I pump.
This is what I tried. Removed the brake line connecter at the caliber, and then pumped still nothing so i moved to the mater cylinder removed the connector at the top of it and pumped and no fluid squirted out of the top and the reservoir stayed full.
So Im assuming it must be the master cylinder, but it worked just fine before I replaced the pads. Could it have went bad just like that? and does it need to be rebuilt or just cleaned or something?
This is what I tried. Removed the brake line connecter at the caliber, and then pumped still nothing so i moved to the mater cylinder removed the connector at the top of it and pumped and no fluid squirted out of the top and the reservoir stayed full.
So Im assuming it must be the master cylinder, but it worked just fine before I replaced the pads. Could it have went bad just like that? and does it need to be rebuilt or just cleaned or something?