thecsfour
05-17-2012, 11:44 AM
I am in the process of removing and replacing the bearing carrier. It probably was never done on this quad. It is a 1997 300EX.
I have been following the "How To" thread and finally got to the point of removing the axle.
When I hit it with the mallet the bearing carrier came out with the axle. Or I should say part of the bearing carrier came out. It was broke on the inside of the swing arm. So when the axle came out part of the carrier came out. Now I can not get the remaining part of the carrier off the axle.
Is the spacer that is on the inside of the bearing carrier a press fit onto the axle????
Because it does not want to come off the axle.
Any ideas anyone??
I have been following the "How To" thread and finally got to the point of removing the axle.
When I hit it with the mallet the bearing carrier came out with the axle. Or I should say part of the bearing carrier came out. It was broke on the inside of the swing arm. So when the axle came out part of the carrier came out. Now I can not get the remaining part of the carrier off the axle.
Is the spacer that is on the inside of the bearing carrier a press fit onto the axle????
Because it does not want to come off the axle.
Any ideas anyone??