ansimation
05-16-2012, 07:59 PM
I currently have the front end of my 426 torn apart while waiting on my +2 houser's to arrive but I was wandering if this is something I will be able to do on my own? I had to tap the spindles with a hammer to get them to drop out since they were pressed in originally. Will I have to press them again when I install them? Not sure how to do that.
Also since I have the tie rods out I will be putting my old tie rod ends on the new rods and re-installing them. I just adjust until the tires are straight, right?
Been reading for hours on camber/caster/toe adjustments but for the most part I think those are things I will have to play with to get "right". However, I can't find anything on actually attaching the spindles to new arms.
Thanks,
Travis
Also since I have the tie rods out I will be putting my old tie rod ends on the new rods and re-installing them. I just adjust until the tires are straight, right?
Been reading for hours on camber/caster/toe adjustments but for the most part I think those are things I will have to play with to get "right". However, I can't find anything on actually attaching the spindles to new arms.
Thanks,
Travis