IMS roll peg question

[askmd]

I have a set of IMS roll pro series pegs I purchased them as 86-87 models but when tried to install them I found the pin that travels through the mount , spring and peg is too large for the hole in the peg does this mean these pegs are for the 88-89 models I heard they have a smaller pin , I dont see a model # on these so how can I find out ?

[croat1]

the thru hole on both the 86/87 and 88/89 ims pegs pegs measures around .405/400 dia.

if you can please post a pic of your ims pegs. the 86/87 and 88/89 ims pegs will mount on either generation frame but the ergonimics will be off (too far down/back and vice versa).

i have bothe sets of pegs....some have to have the pin slightly tapped (hammer) thru because of the powerder coating thickness.