GetOut&Ride
04-19-2012, 07:37 AM
Have a 24mm d-slide carb (from the Apex OEM 70 setup) that previous owner apparently had gone through. This is the keihin style knock off from YSN (uses Keihin PE/PWK jets).
I gave up trying to tune it and went to a round slide PE as the needle in this d-slide was messing up all my attempts to jet with change in temperature (needle was real thin taper with no markings on it and even with a 110 main it would still run rich).
To save anyone out here similair frustration I'm thinking of selling without any jets/needles for spare parts and/or you drop in your own jets & needle (for a 'normal' combo that follows some sort of normal logic to adjust for temp/humidity changes).
Will come with carb body & everything else except for jets, needle (gaskets, spring & plastic bushing, air screw, idle screw, bottom bowl nut, etc.)
First $40 (I'll cover shipping) takes it
I gave up trying to tune it and went to a round slide PE as the needle in this d-slide was messing up all my attempts to jet with change in temperature (needle was real thin taper with no markings on it and even with a 110 main it would still run rich).
To save anyone out here similair frustration I'm thinking of selling without any jets/needles for spare parts and/or you drop in your own jets & needle (for a 'normal' combo that follows some sort of normal logic to adjust for temp/humidity changes).
Will come with carb body & everything else except for jets, needle (gaskets, spring & plastic bushing, air screw, idle screw, bottom bowl nut, etc.)
First $40 (I'll cover shipping) takes it