I have two questions

[bradenc19]

I have a 450 R front master cylinder and the 450R break set up on plus 2 A-arms, do I get break lines for the 450R or the 250R? whats the total length I should run?


Also I have a 39mm airstriker carbr, is there different types of cables with ends? If so what kind do I use?

[beerock]

450r brakelines


the 39mm have a different throttle cable depending on what carb your coming from... 38 airstryker should be the same

[bradenc19]

w/ pluse 2 a-armes how maney inches should the 450r brake lines b 50 52 or 54 inches. thanks thats it for now i will try to get some pic of it. WOODS WARROIR:

[SilverLake250R]

Get 250r brake lines. Reason is, the 450r has an off-center mounting position and one of the lower lines will be longer than the other.

[bradenc19]

thanks i want to run 2 lines how long should they be? i think 50 inches is 2 short. i have a new set but their an inch to short but they have a split in the middle were it mounts to the frame putting my first woods bike togeather. looks good so far i try get some pics. so 250r lines will work w 450r brakes

[beerock]

Originally posted by SilverLake250R
Get 250r brake lines. Reason is, the 450r has an off-center mounting position and one of the lower lines will be longer than the other.

ahhh i thought they were same length

as long as the calipers and master cylinder have the sme fitting then your good, i was not sure about that either so i said 450r lines...


braden why do you want to run two lines? instead of one to a t connector?

[SilverLake250R]

Yup, the fittings are the same.

[bradenc19]

i heard u get better fluied to the capliers so u can stop better. how do u put pics on here cnt figure it out

[beerock]

my opinion is that two brake lines by the handle bars give you 1 more problem if you happened to get snagged on something..mor elevarage to snap the bolt that holds the two lines. two lines are great for a street race bike with huge calipers...

do what you want though.

[bradenc19]

thanx i run xc so i gusse i go w one. What about the carb 39mm airstiker can i use a stock style cable HELP Also cnt get pics on here PLEASE HELP W THAT

[89trx250r]

Im pretty sure they dont make a 39mm airstryker just normal pwk...And motionpro should have any cable you need.

[bradenc19]

ITS A 38MM THEN SORRY I TRIED MY STOCK 250R TRIKE CABLE GOT IT TOGEATHER AND WORKS BUT THE SLID DNT CLOSE ALL THE WAY U CAN SEE THRU THE BOTTOM W THE CABLE OFF IT CLOSES ALL THE WAY IS IT SUPOSEDNTO DO THAT

[89trx250r]

No the slide is supposed to close fully...Did you read what I said about motionpro having the cable you need most likely...

[beerock]

if you got it on there is the throttle adjustment all the way in? if it is and the slide is still open a fair amount then youll need another cable.. but if you can get the slide close to closed with that cable youll be ok as long as the bike stalls out with the throttle cable adjusted all the way in... then back it out till it idles.. thats how i set my idle. I rarely use the idle screw..

if you adjust all that and it runs but the idle is too high then youll need to get a cable..