gcc germany
04-02-2012, 02:00 PM
hey guys!
I have a hinson clutch billet and I have a question.
In the instruction manual at part number 4.Install retainer plate
at part four.
-Using a hammer and punch, peen the screws where they come through the inside of the pasket.
that´s will when I punch one time with the hammer of it or must the pin´s clomplete bear on the clutch?
thanks
I have a hinson clutch billet and I have a question.
In the instruction manual at part number 4.Install retainer plate
at part four.
-Using a hammer and punch, peen the screws where they come through the inside of the pasket.
that´s will when I punch one time with the hammer of it or must the pin´s clomplete bear on the clutch?
thanks