PDA

View Full Version : WTB: Sliders


JustinBoots
03-28-2012, 02:43 PM
Does anyone know where I can get sliders that are less than 3.0 grams? I ordered Dr Pulley 3.5s and 3.0s to go in my Dr Pulley variator, but they are just too heavy for the 50cc engine I'm running in the DRR. I was running 3.0's for regular rollers and understand I should be running .5g smaller in slider application.
djdfairchild
03-28-2012, 07:20 PM
you can run rollers in the dr pulley variators, i have always ran rollers and not had a problem
JustinBoots
03-28-2012, 07:22 PM
May end up having to do that, but hoped to take advantage of sliders. I've seen people reference 2.5 gram sliders, just not sure where I can get them....checed Gary, MarxRPM, Hetrick, and HotQuads. Hunting through Scooter supply sites next.
jhi
03-29-2012, 03:19 AM
check with Buggy parts NW in California
JustinBoots
03-29-2012, 05:22 AM
No luck there or any other places I'm looking.....maybe I need to go with a heavier torque spring since it looks like 3.0g is the lowest they make in sliders. Here's goes tuning all over again. :) I can always fall back on the roller combination I was using earlier if that doesn't work out.