looking for spare cylinder prefer 310

[jhtrx250r]

Looking for a spare un ported cylinder set up. would be nice if it came with a piston.
I would prefer a aftermarket 310-330
at a reasonable price
would also be open to a nice stock cylinder piston combo if the price was right.
This will be a top end to put on a back up motor

[sand_blaster]

Have a price in mind? I have a ESR 310 ported by Nate Macoy with piston. I was thinking $350..

[jhtrx250r]

I really dident want one that was ported already
You can send pics to my email
jhtrx250r@yahoo.com and ill kick it over?
The problem is I can get a esr cylinder, head, piston, gaskets all new for $499. So buying used esr stuff is tough to stay cost efficient.

[sand_blaster]

Oh alright.. I'll send a pic or two. We can work on a price if you like it.

[jhtrx250r]

Sandblaster any pics?

[sand_blaster]

Pic has been sent

[fourtrax_r]

i have a 86 style re sleeve 295 if your interested, no porting was done

[jerorski]

i have a pro-x 330cc cylinder, head and spacer plate, esr trx9 port job done, $300 shipped,call or text 443-250-4755 for pics.

[sand_blaster]

Sooo haven't heard one word from you! Thats a no on my esr?

[timmersam]

pm'ed you sand_blaster

[jhtrx250r]

Sand_blaster , the picture you sent me was of your quad with the cylinder installed.
Is it currently on your quad? The pictures I'm after would be of the condition of the cylinder like the bore, bottom view of any port work done, piston size and condition. That's what I'm after to see if its something I can work with , like I had said earlyer I am looking for un ported , but if only minimum port work was done and I could see that in a good close up picture that would be ok.
Jerorski, if you send some good pics to my email which is listed above.
Showing the port work and sleeve condition I will check out your jug, what bore is it on ? Size in mm and dose it have a piston / rings
with it?

[sand_blaster]

Ahhh alright, yah its like trx9 i believe, just thought I would ask :)

[jhtrx250r]

Sand_blaster, I'm sure nate macoy dose a better job porting than a esr trx9 , a 5yr old with a file could do a better job than esr, if the porting looks ok it might work ?

[jerorski]

i will try to get you some pics tomorrow,no piston and rings, the porting was done by esr, real nice trx9 port job, will measure it tomorrow, cylinder looks good to me, could use a dinkleberry hone clean up.

[jerorski]

pics sent