2012 Indy Show Build Pics

[Dave400ex]

For the 5th year it was featured in the Maier plastic booth. I want to thank Jeff Lewis and everyone at Maier for allowing us to do this! Also a big thank you to all the companies that helped with the build.

Maier
ArsFX
Exit Shocks
DWT
Quadtech
Rath Racing
HMF
Streamline Brakes
PowerMadd
Spider Grips
ASV Inventions
IMS Products
Precision Racing Products
CV4
Rekluse
ORP
LSN Custom Powdercoating
Wide Open Motorsports
IXCR
Hilltop Motorsports
Spider Graphix

[Dave400ex]

Precision Products

[Dave400ex]

Side

[Dave400ex]

ArsFX/Exit Front End

[Dave400ex]

HMF Exhaust

[Dave400ex]

RPM Dominator 2 Axle and Anti-Fade

[Dave400ex]

Sitting on the Ground

[Dave400ex]

Ready for Plastic

[Dave400ex]

Another view

[Dave400ex]

At the Show

[Dave400ex]

:D

[Dave400ex]

Close Up

[Dave400ex]

Angle

[Dave400ex]

Rear End

[Dave400ex]

:eek2:

[Dave400ex]

:)

[Dave400ex]

Final Picture, in the Maier Booth.

[desratt]

what is infront of the radiator

[nubsmoke]

ORP radiator gaurd? good product!

[Dave400ex]

That is a Ockerman Radiator Guard. Keeps it from getting packed full of mud. The ORP rotor guards are a great product too!

[nubsmoke]

Originally posted by Dave400ex
That is a Ockerman Radiator Guard. Keeps it from getting packed full of mud. The ORP rotor guards are a great product too! No good pics of rotor gaurd. Curious on ORP's take on this part.

[Dave400ex]

Here is a picture from last years build of the inside rotor guard.

[nubsmoke]

Originally posted by Dave400ex
Here is a picture from last years build of the inside rotor guard. My bad, saw the FRONT rotor gaurds in the previous pics. Nice gaurds BTW! Never had issues with front rotors, but have been thinking about upgrading.

[Dave400ex]

On the rear we are running the setup built by Burrows. You can get the rear setup through Jet Suspension.

[DnB_racing]

Dave I see youve been running both kick and e-start for a couple years now,

just a question for you ..do you notice the kick arm start gets kinda hot?

im not sure if mines getting hot from a bearing or if its normal ...i know on a kick alone it doesnt get as hot,

im not sure if on the combination kick and e start if the extra gears turning cause the extra heat or if I have something going wrong ive opened it up looking for problems and everthing is in check.. so im kinda stumped

[Dave400ex]

Honestly I'm not sure because I always had kicker only. These last two I've built are ridden by Parker but he has never mentioned anything about the kicker, but rarely uses it.