Baseline Jetting ?'s

[MX Jeff]

Looking for somewhere to start for jetting. I'm horrible at it. Stock carb and engine with Motoworks Exhaust & CFM Intake. Basically sea level.

Thanks

[RNL]

Try doing a search or post on Raptorforum.com, lots of info.

[MX Jeff]

Ok will do. Thanks!

[gistmarrs]

Ours is in the shop or I would check for you. Sorry.

[MX Jeff]

Thanks. I ended up taking it in to have it jetted.

[gistmarrs]

We used Dynge's Dyno in Visalia to have it jetted on a Dyno. It sure ran better afterward.

[MX Jeff]

Where are they at in Visalia? What did they charge? I'll see how it runs when I get it back from Moto-One in Clovis, might give them a try. I've been wanting to put my KTM on the dyno...

[gistmarrs]

I think it was about $150 with tuning. Dyno by itself is about $75. Did you get the ktm from texas? I was real intetested in that one. Got a yfz from san diego instead.

[MX Jeff]

No I didn't buy that one. Was a little scared of having it shipped. I've had 2 different nightmares with having things shipped. I already have a 450sx & 505sx, just was thinking about getting another one to use for practice. I need LOTS of practice lol

[MX Jeff]

Bad miss at 1/4-1/2 throttle. Any ideas of what would cause that?

[gistmarrs]

If I were tuning it, I would go way up or way down with the clip on the needle. Usually 1/4 to 1/2 throttle is controlled more by the needle than anything else.

Marrs

[MX Jeff]

Thanks for the input Marrs. I've tried everything. Think it might be time to make a trip to Visalia lol