jhtrx250r
02-01-2012, 08:28 PM
Selling a LRD 300 mx top end.
It is a later style stock cylinder sleeved with a big bore sleeve and hand ported for MX by arlan.
It has a fresh bore and piston with 6hr run time (just broke in and dynoed)
The head has been converted to a O-ring style head.
Dyno sheet showing power curve and 52 rear wheel HP on arlans dyno (now LED)
This belongs to a friend of mine I am trying to help him get the word out for sale.
He went to a LED 350 set up.
This cylinder runs awesome, I rode it at florence last year and it made every bit as much power as my CPI 310 PV. That dynoed at 54 hp
This set up has high compression and must run race gas.
was used with a 38mm PWK A/S carb boyson rad valve (comes with cylinder) and team B pipe (not included) running stock ignition and 13/39 gearing.
He wants $350 plus shipping (should fit in a flat rate med or large box ? )
I am trying to get pics including dyno sheet, just might take a day or two ?
cylinder and head are powder coated silver vein hammer coat.
also comes with 2 spacer plates and the piston (with 6hrs on it) is a CR style so this set up will work on long or short rod motors.
It is a later style stock cylinder sleeved with a big bore sleeve and hand ported for MX by arlan.
It has a fresh bore and piston with 6hr run time (just broke in and dynoed)
The head has been converted to a O-ring style head.
Dyno sheet showing power curve and 52 rear wheel HP on arlans dyno (now LED)
This belongs to a friend of mine I am trying to help him get the word out for sale.
He went to a LED 350 set up.
This cylinder runs awesome, I rode it at florence last year and it made every bit as much power as my CPI 310 PV. That dynoed at 54 hp
This set up has high compression and must run race gas.
was used with a 38mm PWK A/S carb boyson rad valve (comes with cylinder) and team B pipe (not included) running stock ignition and 13/39 gearing.
He wants $350 plus shipping (should fit in a flat rate med or large box ? )
I am trying to get pics including dyno sheet, just might take a day or two ?
cylinder and head are powder coated silver vein hammer coat.
also comes with 2 spacer plates and the piston (with 6hrs on it) is a CR style so this set up will work on long or short rod motors.