gdr8
01-24-2012, 09:56 PM
I have a complete Mallosi Big Bore motor with all acccessories that I'm selling. It has the 45mm crank, the cylinder has been ported by Hetrick, then when I got the motor I had a local engine builder case match the cylinder. It has 155 psi compression and has been run for about 6 local races and still is at 155psi. The motor comes with a nearly new 30mm carb, Hetrick Gen 3 pipe, a almost new Mallossi variator, and overange rear pully, a stage 6 clutch, Dave Carter Slipper Clutch & tranny cover with welded gears, case saver, analog PVL with coil, kick starter cover, water pump, custom motor mounts to raise motor, silcon hoses. New parts included: Red springs for clutch, Mallosi piston,rings and top end gasket kit, 4 new and 1 used Maximum tourque springs along with 4 other ones. 6 sets of new roller weights along with a bunch of slightly used ones. Basicly a complete motor minus a kick starter. This thing ran really well and was very reliable. I am asking $1000.00 plus shipping.
Parts along are worth more than that, we are done with CVT's so selling all that I have left.
I can send pics if you like.
Parts along are worth more than that, we are done with CVT's so selling all that I have left.
I can send pics if you like.